Frames
Spare Led
Spare LED parts are used when an existing lightbox frame still works but one light section, driver, lead or connector needs replacement. Retail stores, malls and expo displays can keep the original frame in service without rebuilding the full unit.
Typical Spare LED replacements
Spare LED covers replacement LED components for existing lightbox frames. It helps keep retail and expo displays lit properly when a section needs to be swapped out rather than rebuilt.
Match the replacement to the current frame profile, illuminated area and power setup before ordering. Johannesburg dust, Durban humidity, Cape Town coastal air and scheduled power interruptions can all influence which LED section or electrical component should be checked first. A clear photo of the inside of the frame often helps identify the correct part.
Take one close image of the failed area and one full image of the complete lightbox before anything is removed. Include the cable entry point, driver label and frame depth where possible. That record makes it easier to replace only the affected section instead of guessing from memory later.
What to prepare before replacement
Have the frame size, site location and issue description ready, whether the lights are dim, flickering or fully off. It also helps to note if the fabric graphic was removed recently, if the unit is wall mounted or hanging, and whether the fault affects one side or the full display. These details point to the likely component that needs swapping.
Use the contact form with the frame dimensions, the existing LED layout and any markings shown on the driver or wiring. Check the frame corners, power supply and connectors before packing or requesting new parts. If the display is in a mall or on an expo stand, mention any access limits for removal and refit.
- Replacement LEDs for existing frames
- Driver and cable details recorded
- Photos of the failed section
Site conditions that affect lighting
Retail lightboxes in busy centres can collect dust inside the profile, especially near entrances and service passages. Expo units are moved, packed and rebuilt more often, so cable strain, connector wear and impact damage should be checked alongside the LED strips themselves. Older installations may also have mixed components from previous repairs.
Coastal stores need extra attention on fittings and electrical parts where moisture can shorten component life. Inland sites often show more dust build-up on diffusers and inside frame channels. After load-shedding or generator changeovers, check whether the issue sits with the LED run or the power supply feeding it.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Information that helps identify parts
Include clear photos of the lit and unlit frame, the power supply, and any dim or failed section. Note whether the replacement is for a retail wall box, a hanging frame, or an expo unit so the correct LED components can be matched.
If available, include previous job photos, packing labels or a shot of the component sticker inside the frame. For hanging units, note the suspension position and where the electrical feed enters the frame so the replacement can be matched to the existing setup.
What our LED Lightbox customers say
Verified Google reviews